Arduino Single power control unit: Difference between revisions
From Yocto Project
Jump to navigationJump to search
(Created page with "File:housemade_relay.png") |
No edit summary |
||
| Line 1: | Line 1: | ||
In order to build a power cutter using a relay module, one must follow the circuit provided in the attachment. | |||
Required hardware: | |||
- 1 BJT transistor 2N2222A | |||
- 1 3.3 kOhms resistor | |||
- 1 1N4007 diode | |||
- 1 relay module (RAS-0510) | |||
- 1 Protoboard or perforated PCB (min 4.5x4.5 cm) | |||
- 1 Two positions terminal block | |||
- 1 male outlet connector and 1 female outlet plug | |||
- 14AWG Wire (as needed) | |||
[[File:housemade_relay.png]] | [[File:housemade_relay.png]] | ||
Revision as of 18:08, 14 December 2016
In order to build a power cutter using a relay module, one must follow the circuit provided in the attachment. Required hardware: - 1 BJT transistor 2N2222A - 1 3.3 kOhms resistor - 1 1N4007 diode - 1 relay module (RAS-0510) - 1 Protoboard or perforated PCB (min 4.5x4.5 cm) - 1 Two positions terminal block - 1 male outlet connector and 1 female outlet plug - 14AWG Wire (as needed)
