|
|
| (227 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| Software developer over several open source languages
| | [[AFT installation]] |
|
| |
|
| === Setup harness server ===
| | [[Manteiner python3-numpy]] |
| ==== Setup NFS ====
| |
| AFT applies Network file system to share /home/tester directory where images and other files used in flashing for PC-devices can be found.
| |
|
| |
|
| ===== NFS is installed ? =====
| | [[Arduino Single power control unit]] |
| To check if the NFS server is installed, we can do...
| |
| <pre>
| |
| root@testing-harness:~# dpkg -l | grep nfs-kernel-server
| |
| </pre>
| |
| | |
| ===== How to install NFS ? =====
| |
| To install NFS these are the required packages...
| |
| <pre>
| |
| root@testing-harness:~# aptitude install nfs-kernel-server
| |
| The following NEW packages will be installed:
| |
| keyutils{a} libnfsidmap2{a} libtirpc1{a} nfs-common{a} nfs-kernel-server
| |
| rpcbind{a}
| |
| 0 packages upgraded, 6 newly installed, 0 to remove and 459 not upgraded.
| |
| Need to get 470 kB of archives. After unpacking 1 884 kB will be used.
| |
| Do you want to continue? [Y/n/?]
| |
| </pre>
| |
| | |
| ===== Sharing /home/tester directory =====
| |
| <pre>
| |
| root@testing-harness:~# mkdir -p /home/tester
| |
| root@testing-harness:~# echo '/home/tester 192.168.1.0/24 (crossmnt,ro,root_squash,sync,no_subtree_check)' >> /etc/exports
| |
| </pre>
| |
| | |
| | |
| ==== Setup DNS cache and DHCP server ====
| |
| DNSmasq provides two services, either of which can be used independently.
| |
| # DNS service
| |
| # DHCP service
| |
| | |
| A local DNS cache can speed up internet browsing because the user's applications will not need to access a domain name server when it looks up a domain name the computer has visited before.
| |
| | |
| ===== How to install dnsmasq ? =====
| |
| To install dnsmasq these are the required packages...
| |
| <pre>
| |
| root@testing-harness:~# aptitude install dnsmasq
| |
| The following NEW packages will be installed:
| |
| dns-root-data{a} dnsmasq dnsmasq-base{a}
| |
| 0 packages upgraded, 3 newly installed, 0 to remove and 459 not upgraded.
| |
| Need to get 0 B/329 kB of archives. After unpacking 886 kB will be used.
| |
| Do you want to continue? [Y/n/?
| |
| </pre>
| |
| | |
| ===== Configure DHCP server for AFT net =====
| |
| To enable the DHCP server of AFT net, you will need to give it a range of IP addresses to hand out. The AFT net server would hand out 92 address starting at 192.168.1.2 and ending at 192.168.1.99.
| |
| <pre>
| |
| echo 'dhcp-range=192.168.1.2,192.168.1.99,10m' >> /etc/dnsmasq.conf
| |
| </pre>
| |
| | |
| To tell dnsmasq which ethernet interface it can and cannot listen on
| |
| <pre>
| |
| echo 'interface=eno1' >> /etc/dnsmasq.conf
| |
| </pre>
| |
