Arduino Single power control unit: Difference between revisions
From Yocto Project
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
In order to build a power cutter using a relay module, one must follow the circuit provided in the attachment. | In order to build a power cutter using a relay module, one must follow the circuit provided in the attachment. | ||
Required hardware: | Required hardware: | ||
* 1 BJT transistor 2N2222A | |||
* 1 3.3 kOhms resistor | |||
* 1 1N4007 diode | |||
* 1 relay module (RAS-0510) | |||
* 1 Protoboard or perforated PCB (min 4.5x4.5 cm) | |||
* 1 Two positions terminal block | |||
* 1 male outlet connector and 1 female outlet plug | |||
* 14AWG Wire (as needed) | |||
[[File:housemade_relay.png]] | [[File:housemade_relay.png]] | ||
Revision as of 18:09, 14 December 2016
In order to build a power cutter using a relay module, one must follow the circuit provided in the attachment. Required hardware:
- 1 BJT transistor 2N2222A
- 1 3.3 kOhms resistor
- 1 1N4007 diode
- 1 relay module (RAS-0510)
- 1 Protoboard or perforated PCB (min 4.5x4.5 cm)
- 1 Two positions terminal block
- 1 male outlet connector and 1 female outlet plug
- 14AWG Wire (as needed)
