Distro Testing Plan: Difference between revisions

From Yocto Project
Jump to navigationJump to search
Line 105: Line 105:
|}
|}


== Update Supported Distros ==
== Update Supported Distro ==


Once all the build sets were executed and all were PASS at least once the Distro can be added to the list of supported Dsitros  
Once all the build sets were executed and all were PASS at least once the Distro can be added to the list of supported Dsitros  

Revision as of 19:13, 5 July 2016

This article is the test plan for Distro testing

About Distro Testing

Distro Testing is intended to catch bugs that are distribution specific using the yocto-autobuilder.

Objectives

  • Verify that Distro executes oe-selftest
  • Verify that Dsitro is able to execute componenets (Eclipse, Toaster, WIC)
  • Veirfy that Distro is able to build per package type (IPK, DEB, RPM)
  • Verify that Distro is able to build different image types (LSB, non LSB)
  • Verify that Distro is able to build per architecture (arm, x86)
  • Verify that Distro is able to build per bootloader (systed, init)
  • Verify that Distro is able to build poky-tiny
  • Verify that Distro executes multilib

Test Strategy

The strategy will be divided in two groups one executed once in GDC autobuilders when the Distro is released (one time testing) and another tested continuously on public autobuilders


GDC Autobuilder

The first time that Distro is released it will be installed on GDC autobuilder and a series of build steps going to be applied to that Distro, once very build set is PASS that distro will be added to the list of supported Distros by QA, this is a only one time testing activity, not executed in every milestone o release test cycle.

Steps

Distro Steps.PNG

Public Autobuilder

Once the distro was first time validated by QA team it will be running on public autobuilder different build set already defined [[]], after that it going to be under the focus of SWAT team

Process

This section describes the process to add a new Distro as supported on Yocto Project


Install Distro

To Be Updated

Execute Build Sets

Build sets to be executed are defined in below table, to add a Distro as supported all the build sets should be PASS

RPM DEB IPK Component Multilib World oe-selftest
ARM x86_64 x86_32 Eclipse x86 64/32 x86_64
init systemd systemd Toaster x86 64/x32 systemd
poky_lsb poky poky_tiny buildtools core-image-sato poky
core-image-lsb core-image-sato-sdk core-image-minimal read_only rootfs poky core-image-sato-sdk
pam init/systemd
Log rotate RPM,DEB,IPK

Update Supported Distro

Once all the build sets were executed and all were PASS at least once the Distro can be added to the list of supported Dsitros

meta-poky/conf/distro/poky.conf

Requirements

HW Requirements

Software Requirements

Environment Requirements

Test execution Cycle

GDC Autobuilder

  • The execution cycle should be applied only one time when Distro is installed on the autobuilder, results under focus of QA team

Public Autobuilder

  • There will be a continuous execution of random build sets defined on autobuilder, results under foucs of SWAT team

Release Criteria/ Exit Criteria

  • All the defined build steps are PASS [#Execute Build Steps]
  • Distro was added to the supported list #